الصفحة الرئيسية > الدوائر المتكاملة الدوائر المتكاملة > SN74LS125N

SN74LS125N

Quad non-inverting bus buffer, 3-state, active-LOW enable, LS TTL, PDIP-14

5000

المخزون الفعال

انتقل إلى الاستفسار

Image for reference only

جزء الشركة المصنعة ： جزء الشركة المصنعة

SN74LS125N

الحزمة ： الحزمة

PDIP-14 (19.3 x 6.35 x 4.57mm, 2.54mm pitch, through-hole)

العلامة التجارية ： العلامة التجارية

فئات المنتجات:：فئات المنتجات

الدوائر المتكاملة الدوائر المتكاملة, واجهة ICs

توصيات أخرى قد تكون مهتماً بها.

SII9396SCNUC-BAR

IS43TR16256BL-125KBLI

الوصف

نظرة عامة على المنتج

The SN74LS125N from Texas Instruments contains four independent bus buffer gates with 3-state outputs controlled by active-LOW enables — essential for sharing a common data bus among multiple sources in a 14-pin PDIP package.

المواصفات الرئيسية

الوظيفة	Quad bus buffer with 3-state outputs
عائلة المنطق	LS (Low-power Schottky)
جهد الإمداد	4.75V to 5.25V
Buffers	4 (independent, non-inverting)
Output Enable	Active-LOW (OĒ, per buffer)
نوع الإخراج	3-state (HIGH, LOW, or high-impedance)
تأخير الانتشار	8-13ns typical
Output Drive	IOL = 24mA, IOH = -2.6mA
درجة حرارة التشغيل	0°C to +70°C
الحزمة	PDIP-14 (19.3 x 6.35mm)

الميزات

Four non-inverting buffers with 3-state outputs
Active-LOW output enable per buffer
High-impedance output when disabled
24mA sink current for bus driving
Diode-clamped inputs

التطبيقات

Bus buffer / driver
I/O port isolation
Multi-source data bus sharing
Level translation (5V to 3.3V with pull-ups)

مقدمة المنتج:SN74LS125N مقدمة المنتج

The SN74LS125N from Texas Instruments contains four independent non-inverting buffer gates with 3-state (tri-state) outputs. Each buffer has a data input (A), a data output (Y), and an active-LOW output enable (OĒ). When OĒ is LOW, Y = A (the buffer drives the bus). When OĒ is HIGH, Y enters a high-impedance state (electrically disconnected from the bus). The 3-state output is the key feature: multiple 74125 buffers (or other 3-state devices) can share a common bus, and only one drives the bus at a time while all others are in high-Z. The 24mA sink current provides strong bus driving capability. The non-inverting function means the output is the same polarity as the input. The 74125 is the complement of the 74126 (which has active-HIGH enables). For bus applications: multiple data sources connect through 74125 buffers to a common bus; a decoder selects which buffer is enabled (only one at a time); the selected source drives the bus. The N suffix denotes the PDIP-14 through-hole package.

مبدأ العمل:SN74LS125N مبدأ العمل

Each buffer in the SN74LS125N operates as a non-inverting pass gate with 3-state control. When OĒ (output enable) is LOW: Y = A; the buffer actively drives the bus line HIGH or LOW. When OĒ is HIGH: Y enters high-impedance (high-Z) state; the output is effectively disconnected from the bus; the bus line is free to be driven by another device. The 3-state output behaves like a switch: enabled = switch closed (Y follows A); disabled = switch open (Y floats). Only one 3-state device should drive a given bus line at any time; if two devices drive conflicting logic levels, bus contention occurs (excessive current flow, potential damage). A decoder or logic ensures exactly one enable is active at a time. The high-Z state is NOT the same as a HIGH logic level — it’s a floating state. Pull-up or pull-down resistors are often used on 3-state buses to define a known logic level when no device is driving. The 24mA sink capability allows the 74125 to drive heavily loaded bus lines.

وصف الدبوس:SN74LS125N تعريف الدبوس ووظائفه

دبوس	الاسم	النوع	الوصف
1	1OĒ	المدخلات	Buffer 1 output enable (active LOW)
2	1A	المدخلات	Buffer 1 data input
3	1Y	المخرجات	Buffer 1 output (3-state)
4	2OĒ	المدخلات	Buffer 2 output enable (active LOW)
5	2A	المدخلات	Buffer 2 data input
6	2Y	المخرجات	Buffer 2 output (3-state)
7	GND	الطاقة	أرضي
8	3Y	المخرجات	Buffer 3 output (3-state)
9	3A	المدخلات	Buffer 3 data input
10	3OĒ	المدخلات	Buffer 3 output enable (active LOW)
11	4Y	المخرجات	Buffer 4 output (3-state)
12	4A	المدخلات	Buffer 4 data input
13	4OĒ	المدخلات	Buffer 4 output enable (active LOW)
14	VCC	الطاقة	Supply (5V)

Application Scenarios:In which products and applications isSN74LS125N مستعمل

4-Source Bus: 4 data sources → 1A-4A; decoder drives 1OĒ-4OĒ (one LOW at a time); all Y outputs on shared bus; selected source drives bus
Bi-Directional Bus: 74125 for output direction + 74125 for input direction; direction signal selects which buffer group is active
I/O Isolation: MCU I/O pin → A; OĒ from direction control; Y → peripheral bus; disconnect MCU from bus when not communicating
Level Translation: 3.3V signal → A (with current-limit resistor); 5V bus on Y; OĒ = LOW; 74125 safely passes 3.3V as valid TTL HIGH

Alternative Models:What chips are recommended as replacements for SN74LS125N

الطراز	الشركة المصنعة	الفرق الرئيسي	الحزمة	Supply
74LS125N	TI/Nexperia	Original TTL version with 5V-only supply, typical propagation delay 10-15ns	DIP-14	5V TTL
74LS125D	TI/Nexperia	Surface-mount SOIC version of LS with identical logic function	SOIC-14	5V TTL
74HC125D	TI/Nexperia	CMOS version with wide 2-6V supply range, lower power consumption and higher noise immunity	SOIC-14	2-6V CMOS
74HC125N	TI/Nexperia	Through-hole DIP version of HC family for prototyping and repair	DIP-14	2-6V CMOS
74HCT125D	TI/Nexperia	CMOS with TTL-compatible input levels, ideal for mixing with LS devices at 5V	SOIC-14	4.5-5.5V TTL-in
74HCT125N	TI/Nexperia	Through-hole DIP version of HCT family for prototyping and repair	DIP-14	4.5-5.5V TTL-in
74LVC125D	TI/Nexperia	Low-voltage CMOS for 1.65-3.6V modern logic with 24mA output drive and bus-hold inputs	SOIC-14	1.65-3.6V CMOS
74LVC125N	TI/Nexperia	Through-hole DIP version of LVC family for prototyping and repair	DIP-14	1.65-3.6V CMOS

The 74125 is a Quad Bus Buffer with 3-State Output (Active-Low Enable). Family variants span from the original LS TTL (5V only) to modern LVC/AUP (down to 0.8V). HC and HCT versions offer 2-6V CMOS operation with HCT providing TTL-compatible input thresholds for mixed 5V systems. CD4000-series equivalents offer the widest 3-18V supply range at the cost of lower switching speed. DIP packages (N suffix) are through-hole; SOIC (D suffix) and TSSOP are surface-mount.